Alliance Laundry Systems CI 1650/325 Cell Phone User Manual


 
6
1
WARNING
Failure to install, maintain, and/or operate this machine according to the manufacturer's
instructions may result in conditions which can produce serious injury, death, and/or
property damage.
Do not repair or replace any part of the machine or attempt any servicing unless specically
recommended or published in this Installation/Operation Manual and that you are qualied
to carry out.
Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the machine is properly grounded and to reduce the risk of re,
electric shock, serious injury, or death.
WARNING
Toxic and re hazards.
Machine produces gases, fumes and lint which may be toxic or catch
re and could result in serious injury or death.
Vent exhaust outdoors and regularly clean lint away from machine.
WARNING
Burn and crash hazards.
Push red nger guard bar daily to test. If ironer does not stop,
do not use.
Turn off and lock out/tag out all power until repaired.
Safety notice
CAUTION: Note for installation
The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local
codes, with the NATIONAL ELECTRICAL CODE, ANSI/NFPA 70, or Canadian Electrical Code, CSA C22.1.
The installation must comply with local codes or, in the absence of local codes, with the current National Fuel Gas Code,
ANSI Z22.1, or the current CAN/CSA B149, Installation Codes.
The appliance and its appliance main gas valve must be disconnected from the gas supply piping system during any
pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa).
The appliance must be isolated from the gas supply piping system by closing the equipment shutoff valve during any
pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.5 kPa).
There must be provisions for adequate combustion and ventilation air, clearance around air openings and accessibility
clearances for servicing and operation.