Filter
Top Products
All four LEDs are on
80% - 100%
Note: Since your iPhone charges before your PowerCase, you will not see charging
progress on the PowerCase while the iPhone is charging. This is normal.
Charging and syncing with a computer
[Insert image of iPhone being connected to PowerCase and PowerCase connected by cable to a
notebook computer. Similar to IP-PLC3 user guide image.]
1. Connect your iPhone to the PowerCase
2. Connect the PowerCase to your computer using the included USB cable.
3. Your iPhone will now charge and you can sync your iPhone to your computer as usual.
Note: Your iPhone will charge first then the PowerCase will charge (see Charging your
PowerCase section above).
Technical Specifications – Model: IP-PC500
Lithium Polymer battery capacity: 1700mAh
Input charge power: 5VDC / 500mA
Output power: 5VDC / 500mA
Battery lifetime: > 300 full charge cycles
Overvoltage, over-current, and short circuit output protection
Normal operating temperature range: 0 ~ 45°C (32F ~ 113°F)
Normal storage temperature range: -20 ~ 45°C (-4F ~ 113°F)
Limited Warranty
Mizco’s responsibility with regard to this limited warranty shall be limited solely to the repair
or replacement at its option, of any product, which fails during normal consumer use for
a period of 1 Year from the date of purchase. This warranty does not extend to damage or
failure, which results from misuse, neglect, accident, alteration, abuse, improper installation
or maintenance. If at any time during the 1 Year period following the purchase the product
fails due to defects in materials or workmanship, return the defective product with freight
prepaid and proof of purchase.
All brands represented herein are registered trademarks of their respective manufacturers.
Design and specifications are subject to change without notice.
WARNING ! IMPORTANT SAFETY INSTRUCTIONS !
Failure to read and follow these safety instructions could result in fire, explosion, electrical
shock or other hazard, causing serious and/or fatal injury and/or property damage.
1. Do not modify, disassemble, open, drop, crush, puncture or shred the product