HP (Hewlett-Packard) E6380-90019 Cell Phone Accessories User Manual


 
26 Chapter 1
Getting Started
Changing the Test Set’s Display
Changing the Control Fields
There are several types of control fields in the Test Set. This section
describes some of the different types of fields.
Unit-of-Measure Field
Unit-of-measure can be changed to display measurements in different
values or magnitudes. The unit-of-measure field can also be used to
turn a measurement on or off (use the On/Off Yes key).
Figure 1-2 Unit-of-Measure Field
To change a unit-of-measure field
Step 1. Position the cursor at the unit field on the display.
Step 2. Press a key labeled with a different unit-of-measure
(such as W).
If the new units are valid, the measurement value is displayed
in the unit.
If the new units are not valid, the message Invalid
keystroke. is displayed and the units are not changed.
Unit-of-Measure
Main Menu