Filter
Top Products
8 Quick Start Guide
4. Installing Battery
Make sure your device is turned off before installing the battery. You also need
to remove the back cover before you can install these components.
To remove the back cover
1. Make sure your device is turned off.
2.
Hold the device with both hands and the front
panel facing down.
3.
Push the back cover up with your thumb until it
disengages from the device and then slide it up
to remove.
To install the battery
1. Align the battery’s exposed copper contacts
with the battery connectors inside the battery
compartment.
2.
Insert the contact’s side of the battery first and
then gently push the battery into place.
3.
Replace the back cover.
5. Charging the Battery
New batteries are shipped partially charged. Before you start using your device,
it is recommended that you install and charge the battery.
To charge the battery
1. Connect the USB connector of the AC adapter to the sync connector on your
device.
2.
Plug in the AC adapter to an electrical outlet to start charging the battery.
The battery is fully charged after about 3 hours of charging.