Open as PDF
IIKKEELLIITTEE VVIIDDEEOO CCAASSEE
SSUUPPPPLLEEMMEENNTTAALL IINNSSTTRRUUCCTTIIOONNSS FFOORR
##66003388..8833 SSOONNYY DDCCRR--SSRR119900,, 220000,, 229900,, 330000
This supplemental set of instructions describes additional features specific
to your housing model. Prior to testing the system in the water, please read this
supplement along with the general instruction manual to become familiar with
its features and functions.
Ikelite Video Cases are slightly negative
in salt water for stability. This housing has
been water pressure tested at the factory
and has a working depth of 60m (200').
• Power On/Off / Mode
• Power Zoom
• LCD Screen Control #1
• LCD Screen Control #2
• LCD Screen Control #3
• LCD Reversing Circuit On/Off
MMAAIINN OO--RRIINNGG ##00110099__________________________
O-rings last several years if
properly maintained. Control seals
should not need to be replaced as
long as the control shafts are kept
clean and lightly lubricated.
#6038.83 Sony DCR-SR190, 200, 290, 300
PP RR EE PP AA RR AA TT II OO NN
PPAACCKKAAGGEEDD WWIITTHH HHOOUUSSIINNGG
• External UR/Pro Color Filter
• Internal Lens Shade
• Silicone Lubricant
The installation and usage of the external UR/Pro
color filter is described in the general instruction manual.
The internal lens shade helps block light reflection/
refraction caused by the interaction of the external color
filter and the port.
Carefully thread the lens shade on the front of the
camera lens. The lens threads are very fine;
cross thread. It should screw on
very easily. If it is difficult to turn, you are cross threading.
Completely thread the lens shade into the camera to avoid any potential
clearance or sealing problems when the camera is installed and the housing is sealed.
LLCCDD MMOONNIITTOORR // EEXXTTEERRNNAALL MMIIRRRROORR
The camera's LCD monitor can be viewed from the rear of the housing, using the
external mirror featured on the side of the housing.
Open the LCD monitor on the camera, rotate 180°, and then press it back against
the side of the camera. The external mirror is hinged so that it can be opened to reflect
the image from the camera's LCD monitor for viewing from the rear of the housing.
During transportation, please remember to close the mirror by pressing it against
the rubber on the lid snap.
BBAATTTTEERRYY AANNDD TTAAPPEE
Install a fully charged Sony battery on the camera:
Sony NP-FP50, NP-FP60, NP-FP90
Other brand batteries may not fit inside the housing.
Make sure you have loaded an appropriate digital cassette tape in the camera.
OOPPTTIIOONNAALL WWIIDDEE AANNGGLLEE LLEENNSS____________________________________________________________________________________
The housing’s port accepts optional 67mm threaded waterproof Wide-Angle lenses
such as the Ikelite #6420 W-20, Epoque DCL-20 and Inon UWL-100 Type 2 and Sea&Sea
(58070). These waterproof lenses secure to the outside of the lens port.
Should you elect to use the optional Ikelite #6420 W-20, Epoque, Inon or Sea&Sea
lens, carefully thread the waterproof lens on the front of the lens port. The lens threads
are very fine;
cross thread. It should screw on very easily. If it is difficult to
turn, you are cross threading.
NNGGLLEE LLEENNSS OOPPTTIIOONN ________________________________________________________________________________
Special ports are available for use with the Raynox HD-5050 Pro high definition
wide-angle lens. optional ports sold separately as dome port #9304 or flat lens port
#9304.1. Raynox HD-5050 Pro lens not included. Lens
available for purchase