Filter
Top Products
User Guide for the Strobe Phone 1
1GETTING STARTED
Installing the battery
Your Strobe phone comes with a removable
lithium ion (LI Ion) battery.
Fully charge the
battery before using the phone.
To install the battery:
1. Hold the phone face
down.
2. Locate the groove on the
left side of the phone.
Unsnap the hooks and
remove the back cover.
3. Place the battery in the
phone casing with the
metal contacts of the
battery touching the
metal contacts of the
phone.
4. Replace the back panel
by sliding the notches
into the openings on the
left side.
5. Snap the back panel
into place.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter to
the jack on the bottom of
the phone. Do not force
the AC adapter into the
jack. Make sure the
arrow is face up as
shown.
2. Plug the adapter into a wall outlet.
The battery icon in the upper-right corner of the
screen tells you whether the phone is:
• Charging (the icon is animated)
• Partially charged
• Fully charged
Note: The battery will not charge if you use the
phone while it is connected to an AC adapter.
Note: You must use a Kyocera-authenticated
battery in your phone. If you attempt to use a
battery that has not been authenticated you will
receive a security warning.
Contact your service provider to obtain a
Kyocera-authenticated battery.
82-N8758-1EN.book Page 1 Wednesday, May 10, 2006 2:01 PM