Nokia Holder Easy Mount HH-20 and CR-111
The Nokia Holder Easy Mount HH-20 is a mounting device that
allows you to attach the Nokia CR-111 mobile holder to the
windscreen of your vehicle.
Read these instructions carefully before installing and using
the product.
This product may contain small parts. Keep them out of the
reach of small children.
General safety instructions
Only operate the mounting device or mobile holder if it is safe
to do so under all driving conditions. When you install the
mounting device or mobile holder, ensure that they do not
interfere with or hinder the steering or braking systems or
other systems used in the operation of the vehicle (for
example, airbags) or disturb your field of vision while driving.
Check that the deployment of the airbag is not blocked or
impaired in any way. Ensure that the mounting device or
mobile holder is not installed where you might come in
contact with it in the event of an accident or collision.
Periodically check that the suction cup at the bottom of the
mounting device is firmly attached to the windscreen,
especially if the ambient temperature changes a lot. Never
leave the mounting device inside the vehicle in direct
sunlight or in excessive heat. The mounting device and
suction cup may be damaged and adhesion may be impaired
if the inside temperature exceeds +70°C (160°F).
Attach the holder
To attach the mobile holder to
the mounting device, insert
the catch on the mounting
device into the slot at the back
of the holder. Rotate the
holder clockwise about 90
degrees until it locks into
place. When attaching a
mobile holder, ensure that the
display of the mobile device is
clearly visible for the user. For
your safety, install the holder
in the upright position.
To detach the holder from the mounting device, rotate it
anticlockwise.
Attach the mounting device
Before you attach the mounting device to the windscreen,
locate a safe mounting surface on the windscreen, and clean
the surface thoroughly with a glass cleaner and a clean towel.
If the ambient temperature is below +15°C (60°F), carefully
warm the surface and the suction cup with a hair dryer to
ensure a firm grip on the windscreen. Ensure that you do not
heat the windscreen excessively to avoid damage to it.
Product and safety information
© 2009 Nokia. All rights reserved. 83