Filter
Top Products
Internet
104
1999 Nokia Mobile Phones. All Rights Reserved.
To download add-on software
The WWW application can be used to install applications and plug-ins on your
communicator. If you install plug-ins, the WWW application activates them
when necessary.
1 Go to the WWW page where the add-on software package exists.
2 Select the hyperlink that points to the software package.
3 Press Go to fetch the package. After the software package has been
successfully fetched, the software installation view opens.
Press Install. If there is sufficient memory available, the software will be
installed.
Terminal
The Terminal application is started in the Internet main view by selecting
Terminal and pressing Select. The Terminal application is used to connect
directly, not via the Internet, to a remote computer by way of a data call.
The Terminal main view shows the defined Terminal connections. The Terminal
application is similar to the Telnet application, in that both of them emulate
the VT100 terminal display. See figure 10.
To connect with a pre-defined Terminal connection, select the connection and
press Connect.
To create new or edit existing connections, press Define.
To change the settings for incoming data calls, press Settings, select the
setting and press Change. The available settings are:
Local echo for incoming data call — If set to On, characters typed from the
communicator keyboard are echoed locally to the communicator. If set to Off,
they are echoed to the remote host computer.
Caution: Beware of viruses. Only
install on the communicator
software you have obtained from
sources that offer adequate
protection against viruses.