Filter
Top Products
Special features
36
1999 Nokia Mobile Phones. All Rights Reserved.
To print using the cable connection
1 Go to the System application and set cable as the connection type. See
”System settings” on page 125.
2 Connect the communicator to a serial printer with the RS-232 adapter
cable DLR-2.
3 Press Printers and select the correct printer driver.
4 Press Start to start printing.
Document outbox
When you send faxes, short messages and mail, they always go first to the
Document outbox. The outbox prepares your document and then sends it via
the phone. If the phone is off, or the cellular signal strength is inadequate, the
document will not be sent until the phone is switched on and the signal
strength is sufficient. If the phone or fax called is off or busy during the first
attempt, the Document outbox attempts to send the document nine more
times. If the sending still fails, the communicator informs you of this with a
note.
The Document outbox can be accessed in the main views of the Fax, SMS, Mail
and Notes applications, where it is shown at the bottom of the folders list. To
open the Document outbox, select it from the folders list and press Open.
The main statuses that documents can have in the outbox are:
Sending — The document is currently being sent.
Waiting — The document is waiting for sending to become possible, e.g. when
the phone is switched on, cellular signal strength becomes adequate, previous
phone call ends.
Retry [time] — Sending of the document failed and it will be sent again at the
time specified in the square brackets.
At [time] — The fax is waiting to be sent at the time you have specified. See
”Fax settings” on page 74.
Sending [current page/total pages] — The number of the fax page that is being
sent and the total number of the pages.
Figure 3