Filter
Top Products
Computer connectivity
40
1999 Nokia Mobile Phones. All Rights Reserved.
To install the PC Suite on a PC
The CD-ROM should launch itself automatically after you have inserted it into
the CD drive of your PC. If not, please, follow these steps:
1 Click the Windows “Start” button; then click “Run”.
2 If your PC has Windows 95, 98 or NT 4.0 (or later), type d:\9110.exe in the
command line. If your PC has Windows 3.x, type d:\data\9110_31.exe.
Substitute the letter “d” with the letter of the CD drive.
3 Press Enter.
4 Follow the instructions shown on the screen.
To use the PC Suite with an infrared connection
1 The IrDA software must be installed and running on the PC. To check if the
IrDA driver is already installed on the PC, go to the Control Panel. If there is
an icon called Infrared, the driver has been installed.
2 Make sure that the infrared port of the communicator faces the infrared port
of the PC. Keep the infrared link clear: check the infrared indicators in the
indicator area, see ”Communicator display” on page 20. If the infrared link is
obstructed for too long, for example, if something is moved between the
infrared sensors or the communicator is moved, the operation is interrupted.
3 Start the PC Suite software on the PC. In the Preference dialog, select IR as
the data transfer protocol, and the correct COM port.
4 Start the Infrared activation application on your communicator and press
Activate. See ”Infrared activation” on page 131.
To use the PC Suite with a cable connection
1 Connect the 9-pin end of the RS-232 adapter cable DLR-2 to the COM port
of the PC, and the other end to the connector at the bottom of the
communicator. See ”Connectors” on page 26.
2 Start the PC Suite software on the PC.
Note: The PC Suite for Nokia 9110
Communicator program can be found
in the Menu under the heading “PC
and Macintosh software”.
Note: Remember to make
backup copies of all
important data!
Tip: You can also use the optional
deskstand for easy PC connectivity.
See the Accessories guide.