Filter
Top Products
E-12E-11
Preparing the case
Before shooting, prepare the case as described below.
:
When not using the diffuser plate, place it on the center
part on the front of the case as shown on the right.
CAUTION
Attaching/removing/ the diffuser plate
This case is equipped with a diffuser plate that can be used to
attenuate the flash light.
Use the diffuser plate to weaken the shadow of the subject as well as
to attenuate the light.
The diffuser plate can be attached or removed as shown below.
Connection to the camera case
To perform underwater TTL shooting using this case, connect the
underwater TTL cable between this case and the camera case. Connect
the hot shoe cable (provided with this case) between the TTL cable
connector in the camera case and the camera’s hot shoe.
1)Connecting the underwater TTL cable
Make sure that both case’s are dry, and loosen and remove the
TTL cable connector cap from each case.
After removing the cap, connect either end of the underwater TTL
cable connector to the uncapped TTL cable connector in the case.
Pay attention to the following points ;
ᕃ check the orientation of
the 5 pins in the TTL cable’s connector and align it so that the pins
fit into the corresponding receptacles in the case’s TTL connectors
ᕄ turn the lock dial screw on the TTL cable’s connector all the way
clockwise to lock the connector firmly.
The underwater TTL cable can be disconnected from each case by
reversing the above
connection steps. In the final
step, screw the cap back
onto the case’s TTL cable
connector until it is stops.
:
•
Always make sure that the case are completely dry before
connecting or disconnecting the underwater TTL cable.
• O-rings are attached to the case’s TTL connector caps
and the underwater TTL cable’s connectors to keep out
water. If any fibers, sand or hair are attached to an O-
ring, the integrity of the waterproof function will be
affected and water penetration may result. Be sure to
check and remove any foreign matter on the O-rings
before connecting these connectors.
• Pay attention to the position of the 5 pins when
connecting the connectors.
• Do not use excessive force when tightening the lock dial
screw on the cable’s connector.
• When the underwater TTL cable is not connected, be
sure to put the caps back on the TTL cable connectors.
CAUTION
*PFL-01(E).qxd 03.11.27 3:14 PM ページ E-11 (1,1)