Filter
Top Products
Changing Your Settings 64
Press Options ➔ Create, and press the Select soft key or
the key to create a new connection.
Note:
MEdia Net, AT&T MMS, and AT&T IMS are pre-configured and cannot
be altered on this screen. Your phone is set up by default for
connecting to the network.
3. Select one of the following parameters to edit. They may or
may not appear depending on the Network Profile that was
selected:
•
Set name
: enter a profile name.
•
Access name
: edit the access point name.
•
Auth type
: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
•
User ID
: enter the User ID required to connect to the network.
•
Password
: enter the user password required to connect to
the network.
•
Protocol
: set the connection protocol used by the WAP browser:
WAP, HTTP, or Other.
•
Home URL
: enter the URL address of the page to use as
your homepage.
•
Proxy Address
: MEdia Net set as the proxy server address
and port. This option only appears when the Protocol is set to HTTP.
• Gateway Address
: Enter the Gateway Address. This option only
appears when the Protocol is set to WAP.
• Secure connection
: Select On or Off depending on whether or not
you have a secure connection. This option only appears when the
Protocol is set to WAP.
•
Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there is no new data traffic.
•
Advanced
: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic
Class. Highlight this option and press the Edit soft key to access the
following options:
–
Static IP
: specify if you want to manually enter an IP address. Remove
the check mark if you want the server to automatically assign the IP
address.
–
Local Phone IP
: allows you to configure the local phone IP address.
–
Static DNS
: specify if you want to manually enter the Domain Name
Server (DNS) address. Remove the check mark if you want the server to
automatically assign the address.
–
Server 1/Server 2
: enter the Domain Name Server (DNS) addresses.
–
Traffic class
: select the traffic class, press the Edit soft key, select a
Traffic Class (Subscribed, Conversation, Streaming, Interactive, or
Background) and press the OK soft key.
Note:
The WAP settings varies depending on the service provider.