Filter
Top Products
14
FCC Regulations and Requirements
Part 15 of FCC
Rules Information
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Your equipment has been tested and
found to comply with the limits of
a Class B digital device, pursuant to
Part 15 of FCC rules. These limits are
designed to provide reasonable protec-
tion against harmful interference in
residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation; if this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, you are encouraged to try to
correct the interference by one of the
following measures:
1. Where it can be done safely,
reorient the receiving televsion
or radio antenna.
2. To the extent possible, relocate the
television, radio or other receiver
with respect to the telephone equip-
ment.
(This increases the separation
between the telephone equipment and
the receiver.)
3. Connect the telephone equipment
into an outlet on a circuit different
from that to which the television,
radio, or other receiver is connected.
4. Consult the dealer or an experienced
Radio/TV Technician for help.
CAUTION:
Changes or modications to
this equipment not expressly approved
by the party responsible for compliance
could void the user’s authority to oper-
ate the equipment.
Privacy of communications may not be
ensured when using this phone.
CAUTION:
To maintain the compliance
with the FCC’s RF exposure guideline,
place the base unit at least 20cm from
nearby persons.
For body worn operation, this handset
has been tested and meets the FCC RF
exposure guidelines when used with the
(Plantronics) accessories supplied or
designated for this product. Use of other
accessories may not ensure compliance
with FCC RF exposure guidelines.
Industry Canada
Technical Specications
This product meets the applicable Indus-
try Canada technical specications.
Before installing this equipment, users
should ensure that it is permissible to
be connected to the facilities of the
local telecommunications company. The
equipment must also be installed using
an acceptable method of connection. In
some cases, the company’s inside wiring
associated with a single line individual
service may be extended by means of a