GE IC300TIU111 Cell Phone User Manual


 
PAGE 22 06 Apr 2000 CH.3: TIU100/101/102/103
GFK-1819
Termination
resistance of 120
must be placed across each end of the RS-485 bus. With switch 2 ON,
a 120
resistance is placed across the bus. This should only be used if the TIU050/100/110 is the last
device at either end of the bus.
3.6 TIU10X Dimensions
Figure 3.6 Power Connector
Powered by +24VDC and Ground.
Figure 3.7 Configuration Bank
OFF
ON
SW1
Figure 3.8 TIU10X Cutout
UP TO 0.04[1mm] CORNER
RADIUS IS ACCEPTABLE
TOLERANCES ARE +/- 0.01 [0.3mm] UNLESS STATED OTHERWISE
TIU10X CUTOUT DETAILS
3.94 [100 mm]
+0.02
-0.00
+0.5
-0.0
3.27 [83 mm]
+0.02
-0.00
+0.5
-0.0