Filter
Top Products
12 13
cerTIfIcaTIon and safeTy aPProvaLs
CE
This product is CE marked according to the provisions of the R & TTE Directive (99/5/EC). Hereby, GN, declares
that this product is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC. For further information please consult http://www.jabra.com Within the EU this device is intended
to be used in Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece,
Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden,
The Netherlands, United Kingdom, and within EFTA in Iceland, Norway and Switzerland.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Users are not permitted to make changes or modify the device in any way. Changes or modications not
expressly approved by Jabra will void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- The user must place the base 8” (20cm) or more from any personnel in order to comply with FCC RF exposure
requirements.
Industry Canada
Operation is subject to the following two conditions: (1) This device may not cause interference and (2) This
device must accept any interference, including interference that may cause undesired operation of the device.
The term “IC:” before the certication/registration number only signies that registration was performed based
on a Declaration of Conformity indicating that Industry Canada technical specications were met. It does not
imply that Industry Canada approved the equipment.
Bluetooth
The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by Jabra is
under license. Other trademarks and trade names are those of their respective owners.
gLossary
Bluetooth
A radio technology that connects devices, such as mobile phones and headsets, without wires or cords over
a short distance (approximately 33 feet). Learn more at www.bluetooth.com.
Pairing
Creates a unique and encrypted link between two Bluetooth devices and enables them to communicate with
each other. Bluetooth devices will not communicate if they have not been paired.
Jabra PC Suite
A GN Netcom software communication control center.
DFU
Device Firmware Update
Firmware
The software that is embedded in a hardware device, for example the Jabra LINK 280 controller. Like software,
rmware is a computer program, which is executed by a computer.
IP telephony
(Voice over Internet Protocol) The routing of internet voice conversations or through other IP-based networks.