vi
Radio Frequency (RF) energy
Your telephone is a radio transmitter and receiver. When it
is on, it receives and sends out RF energy. Your service
provider’s network controls the power of the RF signal.
This power level can range from 0.006 to 0.6 watts.
In August 1996, the U.S. Federal Communications
Commission (FCC) adopted RF exposure guidelines with
safety levels for hand-held wireless phones. These
guidelines are consistent with the safety standards
previously set by both U.S. and international standards
bodies in the following reports:
• ANSI C95.1 (American National Standards Institute,
1992)
• NCRP Report 86 (National Council on Radiation
Protection and Measurements, 1986)
• ICNIRP (International Commission on Non-Ionizing
Radiation Protection, 1996)
Your phone complies with the standards set by these
reports and the FCC guidelines.
E911 Mandates
Where service is available, this handset complies with the
Phase I and Phase II E911 Mandates issued by the FCC.
Battery and charger specifications
Customer support
Your service provider’s customer support department may
be accessible directly from your phone when you dial a
number such as *611 (check with your service provider).
They can answer questions about your phone, phone bill,
call coverage area, and specific features available to you,
such as call forwarding or voicemail.
For questions about the phone features, refer to the
materials provided with your phone, or visit
www.kyocera-wireless.com.
For additional questions, you may contact the Kyocera
Wireless Corp. Customer Care Center in any of the
following ways:
• Web site: www.kyocera-wireless.com
• Email: phone-help@kyocera-wireless.com
Before requesting support, please try to reproduce and
isolate the problem. When you contact the Customer Care
Center, be ready to provide the following information:
• The name of your service provider.
• The actual error message or problem you are
experiencing.
• The steps you took to reproduce the problem.
• The phone’s electronic serial number (ESN).
To find the ESN:
a. Remove the battery.
b. Locate the white label on the back of the phone.
Your phone’s 11-digit ESN begins with “D” and is
located on the label.
Qualified service
If the problem with your phone persists, return the phone
with all accessories and packaging to the dealer for
qualified service.
Charger Input Output
CV90-60858-01 100-240VAC / 50/60Hz 4.5V 1.5A
CV90-60859-1 120VAC / 60Hz 5.2V 400mA
Standard Battery: 3.6V / 900mAh