Filter
Top Products
User Guide for Kyocera K490 Phones iii
Copyright © 2004 Kyocera Wireless Corp. All rights
reserved. Ringer Tones Copyright © 2000-2002
Kyocera Wireless Corp.
82-M8581-1EN, Rev. 002
FCC/IC Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
To maintain compliance with FCC RF exposure
guidelines, if you wear a handset on your body, use
the Kyocera Wireless Corp. (KWC) supplied and
approved case TXLCC10042B and universal belt clip
TXLCC10047B.
Other accessories used with this device for body-worn
operations must not contain any metallic components
and must provide at least 22.5 mm separation
distance including the antenna and the user’s body.
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limits for exposure to radio
frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
These limits are part of comprehensive guidelines and
establish permitted levels of RF energy for the general
population. The guidelines are based on standards
that were developed by independent scientific
organizations through periodic and thorough
evaluation of scientific studies. The standards include
a substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the
FCC is 1.6 W/kg.*
Tests for SAR are conducted using standard operating
positions specified by the FCC with the phone
transmitting at its highest certified power level in all
tested frequency bands.
Although the SAR is determined at the highest
certified power level, the actual SAR level of the
phone while operating can be well below the
maximum value. This is because the phone is
designed to operate at multiple power levels so as to
use only the power required to reach the network. In
general, the closer you are to a wireless base station
antenna, the lower the power output.
Before a phone model is available for sale to the
public, it must be tested and certified to the FCC that it
does not exceed the limit established by the
government-adopted requirement for safe exposure.
The tests are performed in positions and locations
(e.g., at the ear and worn on the body) as required by
the FCC for each model. The highest SAR values for
these model phones are:
FCC ID: OVFKWC-K493 (Phone model: K493)
PCS/CDMA mode (Part 24) - Head: 1.17 W/kg;
Body-worn: 0.42 W/kg.
FCC ID: OVFKWC-K4X4 (Phone model: K494)
AMPS/CDMA modes (Part 22) - Head: 1.37 W/kg;
Body-worn: 0.66 W/kg.
PCS/CDMA mode(Part 24) - Head: 1.36 W/kg;
Body-worn: 0.47 W/kg.
(Body-worn measurements differ among phone
models, depending upon availability of accessories
and FCC requirements. The body-worn SAR values
provided above were obtained by using Kyocera
Wireless Corp. [KWC] supplied and approved case
TXLCC10042B and universal belt clip
TXLCC10047B).
While there may be differences between the
SAR levels of various phones and at various
positions, they all meet the government requirement
for safe exposure.