Filter
Top Products
FCC/IC Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
To maintain compliance with FCC RF exposure
guidelines, if you wear a handset on your body, use the
Kyocera Wireless Corp. (KWC) supplied and approved
holster (TXLCC10049). Use of other accessories may not
ensure compliance with FCC RF exposure guidelines.
THIS MODEL PHONE MEETS THE GOVERNMENT’S
REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It
is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by
the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for
the general population. The guidelines are based on
standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial
safety margin designed to assure the safety of all
persons, regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6 W/kg.* Tests for SAR are conducted using standard
operating positions specified by the FCC with the phone
transmitting at its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified
power level, the actual SAR level of the phone while
operating can be well below the maximum value. This is
because the phone is designed to operate at multiple
power levels so as to use only the power required to
reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power
output.
Before a phone model is available for sale to the public, it
must be tested and certified to the FCC that it does not
exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the
body) as required by the FCC for each model. The highest
SAR values for this model phone are:
CDMA mode (Part 22)Óhead: 1.22 W/kg,
Body-worn: 0.56 W/kg with KWC holster TXLCC10049;
PCS/CDMA mode (Part 24)Óhead: 0.71 W/kg,
Body-worn: 0.57 W/kg with KWC holster TXLCC10049.
(Body-worn measurements differ among phone models,
depending upon available accessories and FCC
requirements). The body-worn SAR values provided
above were obtained by using Kyocera Wireless Corp.
(KWC) supplied and approved holster TXLCC10049).
While there may be differences between the SAR levels of
various phones and at various positions, they all meet the
government requirement for safe exposure.
The FCC has granted an Equipment Authorization for this
model phone with all reported SAR levels evaluated as in
compliance with the FCC RF emission guidelines. SAR
information on this model phone is on file with the FCC
and can be found under the Display Grant section
http://www.fcc.gov/oet/fccid after searching on FCC ID
OVFKWC-SE47. Additional information on SAR can be