Filter
Top Products
FCC/IC Notice
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6Watts per
kilogram (W/kg). Tests for SAR are conducted using standard operating positions specified
by the FCC with the phone transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the maximum value. This
is because the phone is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output.
Before a phone model is available for sale to the public, it must be tested and certified to
the FCC that it does not exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in positions and locations (e.g., at
the ear and worn on the body) as required by the FCC for each model. The highest SAR
value for this model phone when tested for use at the ear is 0.89 W/kg and when worn on
the body at the waist is 0.34 W/kg. (Body-worn measurements differ among phone models,
depending upon available accessories and FCC requirements). While there may be
differences between the SAR levels of various phones and at various positions, they all
meet the government requirement for safe exposure.
Warning
Use only Kyocera Wireless Corp. approved accessories with Kyocera Wireless Corp.
phones. Use of any unauthorized accessories may be dangerous and will invalidate the
phone warranty if said accessories cause damage or a defect to the phone.
To comply with FCC radiation exposure requirements, use of this device for body-worn
operational configurations is limited to accessories tested and approved by Kyocera
Wireless Corp. Other accessories used with this device for body-worn operations must not
contain any metallic components and must provide at least 22.75mm separation distance