Filter
Top Products
FCC/IC Notice
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
To comply with FCC radiation exposure requirements, use
of this device for body-worn operational configurations is
limited to accessories tested and approved by Kyocera
Wireless Corp. Other accessories used with this device for
body-worn operations must not contain any metallic
components and must provide at least 13.5 mm separation
distance including the antenna and the user’s body. Other
accessories that have not been tested for body-worn SAR
may not comply with FCC radiation exposure limits and
should be avoided.
THIS MODEL PHONE MEETS THE GOVERNMENT’S REQUIREMENTS
FOR EXPOSURE TO RADIO WAVES.
Your wireless phone is a radio transmitter and receiver. It
is designed and manufactured not to exceed the emission
limits for exposure to radiofrequency (RF) energy set by
the Federal Communications Commission of the U.S.
Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for
the general population. The guidelines are based on
standards that were developed by independent scientific
organizations through periodic and thorough evaluation of
scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless mobile phones
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W/kg.* Tests for SAR are conducted using standard
operating positions specified by the FCC with the phone
transmitting at its highest certified power level in all tested
frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the
phone while operating can be well below the maximum
value. This is because the phone is designed to operate at
multiple power levels so as to use only the power required
to reach the network. In general, the closer you are to a
wireless base station antenna, the lower the power output.
Before a phone model is available for sale to the public, it
must be tested and certified to the FCC that it does not
exceed the limit established by the government-adopted
requirement for safe exposure. The tests are performed in
positions and locations (e.g., at the ear and worn on the
body) as required by the FCC for each model. The highest
SAR value for this model phone when tested for use at the
ear is 1.31 W/kg. and when worn on the body, as described
in this user guide, is 0.648 W/kg.(Body-worn
measurements differ among phone models, depending
upon available accessories and FCC requirements). While
there may be differences between the SAR levels of
various phones and at various positions, they all meet the
government requirement for safe exposure.
The body-worn measurements were performed on the
following Kyocera accessories:
Holster CV90-B1680
Leather Case CA90-B1691M
Leather Case CA90-B1691S
SAR testing was performed with production battery CV90-
G8196, Model # TXBAT10003.
The FCC has granted an Equipment Authorization for this
model phone with all reported SAR levels evaluated as in
compliance with the FCC RF emission guidelines. SAR
information on this model phone is on file with the FCC
and can be found under the Display Grant section
http://www.fcc.gov/oet/fccid
after searching on FCC ID
OVFKWC-5135. Additional information on Specific