Filter
Top Products
74
Settings
Phone Lock (Menu 9.5.2)
When the Phone Lock feature is enabled, the phone is
locked and you must enter the phone password each
time the phone is switched on. The password is factory
set to 0000. To change the phone password, refer to
the Change Codes – Security Code menu option [Menu
9.5.5.1]. Once the correct password has been entered,
you can use the phone until you switch it off.
The following options are available:
When Power On
] Off: You do not need to enter the phone password
when you switch the phone on.
] Always On: You are required to enter the phone
password when you switch the phone on.
] When SIM Changed: Your phone will request
security code only when you change your SIM card.
Immediately
After entering the correct security code, the phone will
lock after going into the idle state. If you want to
disable this phone lock, you should enter the right
security code after pressing the right soft key. If you
power off in the phone lock state, when the phone is
next powered on, the phone is in the lock state.
Auto Key Lock (Menu 9.5.3)
When you enable Automatic key lock, keypad will be
lock automatically on an idle screen after selected
seconds without any key requesting. if you set to Off,
keypad will not be locked automatically.
n
Note
If you want to unlock your phone keypad, press the left soft
key [Unlock] and then press the right soft key. But if you
enabled Automatic key lock before, your phone keypad will
be unlock and then after selected seconds the keypad will
be lock up again automatically.
Fixed Dial Number (FDN) (Menu 9.5.4)
Allows you to restrict your outgoing calls to selected
phone numbers, if this function is supported by your
SIM card. The PIN2 code is required.
The following options are available:
] Enable: You can only call phone numbers stored in
the Address Book. You must enter your PIN2.
] Disable: You can call any number.
] Number List: You can view the number list saved as
fixed dial number.