Nokia 5210 Cell Phone User Manual


  Open as PDF
of 4
 
1. INTRODUCTION
Please read all the FAQ documents and other material concerning the Palm OS upgrade
and the Enhanced Infrared upgrade on the Palm's site before continuing.
2. PALM CONFIGURATION
Please upgrade your Palm III/IIIx/V operating system to version 3.30 and follow the
installation instructions given on their web site (http://www.palm.com/custsupp/upgrade/).
NOTE! Palm IIIe cannot be upgraded, Palm IIIc already uses Palm OS 3.5 as does Palm Vx.
After upgrading the operating system, continue by installing the Enhanced Infrared upgrade
(http://www.palm.com/custsupp/downloads/irenhanc.html
). After successful upgrading,
please remember to reset your Palm Pilot before proceeding. Now you can proceed with the
Nokia phone specific steps listed below:
NOTE! There is no need for Palm IIIc, Vx, m500 series users to upgrade the PalmOS
because you already have the latest possible version of PalmOS which has the
enhancement that are required. So, please follow the Quick Guide disregarding any
references to operating system upgrade.
2.1 ABOUT INFRARED IN NOKIA PHONES
When you are making a connection (call) first activate the infrared reception in your Nokia
phone.
3. PALM MODEM CONFIGURATION
4. Tap the Applications button (the round touch button which has a house illustrated on it)
5. Tap the Prefs button
6. Select 'Serial/IR' from the drop-down menu (in the upper right corner)
7. Tap on the 'Infrared' box to use the IrCOMM drivers that you installed earlier. This means
that from now on, all serial communications will take place over the IR port. The most
common usage of serial communications is to carry out HotSync operations using the
cradle. You will need to switch back to 'cradle' in order to carry out HotSync operations
using your cradle
8. Select 'Connection' from the drop-down menu (in the upper right corner) and tap 'New'
9. Complete the required fields making sure you remember the Name of the connection (the
easiest way might be to just use Nokia) and ensure the Connection 'Method' selected is
'IrCOMM to Modem'. This ensures the use of the IrDA drivers that you installed earlier.
1/2
 previous