Filter
Top Products
down, and press
until it locks into place.
Remove the memory card
Important: Do not remove the memory card in the middle of an operation when
the card is being accessed. Removing the card in the middle of an operation may damage
the memory card as well as the device, and data stored on the card may be corrupted.
You can remove or replace the memory card card during phone operation without
switching the device off.
1. Ensure that no application is currently accessing the memory card.
2. Open the cover of the memory card slot.
3. Press the memory card slightly in to release the lock, and remove it.
Charge the battery
1. Connect the charger to a wall socket.
2. Connect the lead from the charger to the charger connector
of your phone.
If the battery is completely discharged, it may take a few
minutes before the charging indicator appears on the display or
before any calls can be made.
The charging time depends on the charger used. Charging a
BL-5CT battery with the AC-3 charger takes approximately 1 hour
30 minutes while the phone is in the standby mode.
Antenna
Your device may have internal and external antennas. As with any radio
transmitting device, avoid touching the antenna area unnecessarily while the
antenna is transmitting or receiving. Contact with such an antenna affects the
communication quality and may cause the device to operate at a higher power
level than otherwise needed and may reduce the battery life.
The figure shows the antenna area marked in grey.
Headset
Warning: Listen to music at a moderate level. Continuous exposure to high
volume may damage your hearing. Do not hold the device near your ear when the
loudspeaker is in use, because the volume may be extremely loud.
Get started
© 2008 Nokia. All rights reserved. 13