1/5
1. INTRODUCTION
For reading and sending e-mail via the Nokia 9210i Communicator remote e-mail client, you
need to have an Internet Access Point (IAP) configured to your communicator. For further
information how to configure IAPs please refer to the user guide.
You also need to have an e-mail account and it needs to support SMTP protocol for sending
e-mail, and POP3 or IMAP4rev1 protocol for receiving e-mail. You can also have multiple e-
mail accounts in the Nokia 9210i Communicator.
Note: The necessary settings for mail configuration are provided by your e-mail
Service Provider. Depending on your Service Provider you may not need to fill in
all of the settings. If your mail settings are incomplete or incorrect, please contact
your Service Provider. An e-mail service provider can be your company or a
commercial ISP, for example.
2. MAIL SETTINGS
In order to connect to your electronic mailbox service, you need to define your remote
mailbox on your communicator.
2.1 TO DEFINE A NEW REMOTE MAILBOX
1. Open Internet startup from Desk or from under Extras.
2. Open Mail account. A dialog with four pages opens.
3. Define the settings on the General, Servers, Retrieve and Advanced pages as described
below.
4. Press Delete to discard any changes.
5. Press Done to accept the changes you have made.
Copyright
Nokia Mobile Phones 2001. All rights reserved
