Filter
Top Products
Copyright
©
2005 Nokia. All rights reserved.
Tools
101
Access point name (for packet data only)—The access
point name is needed to establish a connection to the
packet data and UMTS networks. You obtain the access
point name from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
The user name is often case-sensitive.
Prompt password—If you must enter a new password
every time you log in to a server, or if you do not want to
save your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
The password is often case-sensitive.
Authentication—Select Normal or Secure.
Homepage—Depending on what you are setting up, write
the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the Internet protocol type to use:
IPv4 settings or IPv6 settings. The other settings depend
on the selected network type.
Phone IP address (for IPv4)—Enter the IP address of your
device.
Name servers—In Primary name server:, enter the IP
address of the primary DNS server. In Second. name
server:, enter the IP address of the secondary DNS server.
Contact your Internet service provider to obtain these
addresses.
Glossary: The domain name service (DNS) is an
Internet service that translates domain names such
as www.nokia-asia.com into IP addresses like
192.100.124.195.
Proxy serv. address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data conn.—If you select When available and you
are in a network that supports packet data, the device
registers to the packet data network. Also, starting an
active packet data connection is quicker (for example, to
send and receive e-mail). If you select When needed, the
device uses a packet data connection only if you start an
application or action that needs it. If there is no packet
data coverage and you select When available, the device
periodically tries to establish a packet data connection.