Filter
Top Products
Settings
112
Copyright © 2007 Nokia. All rights reserved.
Access points
You may receive access point settings in a message from
a service provider. See “Data and settings”, p. 55. Some or
all access points may be preset for your device by your
service provider, and you may not be able to change,
create, edit, or remove them. indicates a protected
access point, and indicates a packet data access point.
To create a new access point, select Options > New
access point. Select Use default settings to use the
default access point settings, or Use existing settings to
select an existing access point as the basis for the new
access point.
To edit the settings of an access point, select Options >
Edit. Follow the instructions from your service provider.
Connection name—Enter a descriptive name for the
connection.
Data bearer—Select the data connection type.
Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with
Must be defined or with a red asterisk. Other fields can
be left empty, unless you have been instructed otherwise
by your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
Packet data
Follow the instructions from your service provider.
Access point name—You obtain the access point name
from your service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
your password in the device, select Yes.
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Authentication—Select Normal or Secure.
Homepage—Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options > Advanced settings to change the
following settings:
Network type—Select the Internet protocol type to use:
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4 only)—Enter the IP address of
your device.