Filter
Top Products
[ 9 ]
Phone setup
• CHARGE THE BATTERY
Charge the new battery for three hours
before using the phone. Use the phone until
the battery is fully discharged. You should
do this for a total of three charging cycles.
1 With your phone turned off, connect
the lead from the charger to the bottom of the phone.
2 Connect the charger to an AC wall outlet.
If the phone is turned on, the messages, Charger connected and
Charging appear. The battery power indicator bar starts to scroll up
and down (see “Indicators” on page 15). If the battery is completely
discharged, it will take a few minutes before the charging indicator
appears on the screen.
3 The battery is charged when the battery indicator bar stops scrolling.
Disconnect the charger from the AC outlet and the phone.
Note: If your service provider has activated your service, you can
use the phone while the battery is charging; however, if the phone
becomes too warm while you’re making a call, it automatically
drops the current call and returns to the Start screen. You will not
be able to make or receive calls until the phone cools.
When the charger is not in use
When the charger is not in use, disconnect it from the power source.
Do not leave the battery connected to the charger for longer than a week.
Overcharging the battery could shorten its lifespan. If a fully charged
battery is not used, it will discharge itself over time.