Filter
Top Products
If there is any trouble, disconnect the
unit from the extension line and
connect a known working phone. If
the known working phone operates
properly, have the defective phone
repaired by one of the specified
Panasonic Factory Service Centers. If
the known working phone does not
operate properly, check the
Electronic Modular Switching System
and the Internal extension wiring.
WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR ANY TYPE
OF MOISTURE.
CAUTION:
To assure continued compliance with
FCC rules, do not make any
unauthorized modifications. When
programming emergency numbers
and/or making test calls to
emergency numbers:
1) Remain on the line and briefly
explain to the dispatcher the
reason for the call before hanging
UP.
2) Perform such activities in the off-
peak hours, such as early morning
hours or late evenings.
INSTALLATION:
1) Never install telephone wiring
during a lightning storm.
2) Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3) Never touch uninsulated telephone
wires or terminals unless the
telephone line has been
disconnected at the network
Interface.
4) Use caution when installing or
modifying telephone lines.
NOTE:
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against harmful
interference in a residential
installation. This equipment generates,
uses, and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving
antenna.
-Increase the separation between
equipment and receiver.
-Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an
experienced radio/TV technician for
help.
This telephone provides magnetic
coupling to hearing aids.
-lO-