Filter
Top Products
EN-8
ENGLISHFRANÇAISEESPAÑOL
Install the remote control 4.3 batteries
A
A
A
A
A
A
Open the battery cover on the back of the 1.
remote control.
Insert the 2 batteries supplied. Make sure the 2.
+ and - ends of the batteries line up correctly.
(inside of case is marked).
Close the cover.3.
Connect the antenna or cable4.4
Connect to an antenna
HDMI 2
HDMI 1
CVI 1
CVI 2
AUDIO IN
VGA
PC IN
75 Ω
L-AUDIO OUT-R
Locate the TV ANTENNA connector on the 1.
back of the TV.
Connect one end of an antenna cable (not 2.
supplied) to the TV ANTENNA connectors. Use
an adaptor if the antenna cable does not fit.
Connect the other end of the antenna cable to 3.
your antenna outlet, ensuring that the cable is
tightly secured at both ends.
Firmly pull the stand from the bottom of the 3.
TV. Place both the stand and bolts in a secure
location for future reinstallation.
Step 3 Connect cables
Connect the antenna cable, AC power cord and all
other devices to the back of the TV as described in
the following sections and in Section 7 Connect devices.
Step 4 Secure the VESA-compatible wall
bracket to the TV
Warning B
Only use the specied bolts (M6 x 10mm)
to secure the VESA-compatible wall
bracket to your TV. The specied bolts are
designed to match the weight of your TV.
Note D
Depending on your VESA-compatible wall
bracket, you may need to separate the mounting
plate from the wall bracket for easier installation.
Refer to your VESA-compatible wall bracket
documentation for instructions.