Filter
Top Products
12 Installing the P80 Console Media Adapter
Installing Receivers in Junction Boxes
Each external receiver in your facility must be housed in a
high-capacity junction box. This enclosure is a direct
replacement for an existing T-junction; its ventilation slots
and elevated receiver platform keep the receiver cool during
use, while space has been set aside on its lower level for the
receiver’s power supply.
When you place the receiver in the junction box, position it so
that its controls face upward and its connectors face
downward, as shown in the following figure.
Figure 3: Receiver and cable slot positioning
Note: If you need to pass the HDMI and remote control
cables through the back of the junction box, insert them into
the slot in the base of the box (shown in the previous figure).
To close off unused raceway openings in the box, insert an
end cap as shown in the following figure.
Figure 4: End cap installation in junction box