Filter
Top Products
8
Preparation
2. Hold down
ANNOUNCE
until you hear a
beep (about 2 seconds).
3. After the beep, begin speaking your
message about 8 inches away from the
microphone (located on the front of the
TAD).
4. Press
CODE/STOP
to stop recording.
The TAD automatically repeats the mes-
sage then beeps.
SETTING THE INCOMING
MESSAGE LENGTH
Slide
INCOMING
to
1
or
5 MINUTES
to restrict
the length of incoming messages.
CHECKING AN OGM
Follow these steps to check any OGM at any
time.
1. Slide
ANNOUNCE SELECT
to
1, 2,
or
AO
to select the desired OGM.
2. Press
ANNOUNCE
to play the OGM.
3. To stop the outgoing message before it
ends, press
STOP
.
SETTING THE NUMBER OF
RINGS
The ring select switch on the right side of the
TAD controls how long the TAD waits before
it answers a call. Slide the switch to the ap-
propriate position.
2
— The TAD answers after two rings.
4
— The TAD answers after four rings.
7
— The TAD answers after seven rings.
TS
(Toll Saver)
— If there are new messages,
the TAD answers after two rings. Otherwise,
the TAD answers after four rings. This lets
you avoid unnecessary charges when calling
by long-distance to check your messages. If
you hear more than two rings, you know you
can hang up because the TAD has no new
messages.
43-723.fm Page 8 Monday, May 22, 2000 10:26 AM