Sagem my500x Cell Phone User Manual


 
40 Settings
Phone code
The Phone code menu allows you to activate the phone code so that it is requested and checked whenever the phone is
switched on if a different SIM card is used. This code is automatically linked to the SIM card installed when the phone is
activated, for example to protect the phone if stolen.
Select
Check
and [
Select
].
Enter 0000 (the factory code, by default) and validate.
Select
Activate
or
Deactivate
and validate.
To modify the phone code, select
Modify
and validate.
Enter old phone code and validate.
Enter new phone code and validate.
Enter phone code again to confirm it and validate.
Confidentiality
This menu allows the activation or deactivation of automatic deletion, after power off/on, of outgoing calls, messages stored
or organizer events.
Select
Activate
or
Deactivate
and validate.
Operator
This menu allows you to modify the call barring.
Access to this service depends on your type of subscription.
Call barring
This menu allows you to block the sending or receiving of certain calls.
Before you can use this service, a password will be provided by your operator when you take out your subscription.
Access to this service depends on your subscription type.
To activate call barring :
- Select incoming or outgoing calls.
- Select the call type on which you want to activate call barring.
- Select:
either All,
or If roaming, if you are away from your home country and if roaming is available, only incoming calls will be blocked.
- Select Activation and enter password.
252780489_my500X_my501X_en.book Page 40 Jeudi, 3. août 2006 2:17 14