Filter
Top Products
Changing Your Settings 43
➔
Network Profiles.
2. Highlight one of the following options and press the
View
soft key.
• MEdia Net
• AT&T MMS
• AT&T IMS
Note:
MEdia Net, AT&T MMS, and AT&T IMS are pre-configured and cannot
be altered on this screen. Your phone is set up by default for
connecting to the network.
– or –
Press Options ➔ New, and press the Select soft key or
the key to create a new connection.
3. Select one of the following parameters to edit. They may or
may not appear depending on the Network Profile that was
selected:
•
Set Name
: enter a profile name.
•
Access Name
: edit the access point name.
•
Auth Type
: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
•
User ID
: enter the User ID required to connect to the network.
•
Password
: enter the user password required to connect to
the network.
•
Protocol
: set the connection protocol used by the WAP browser:
WAP, HTTP, or Other.
•
Home URL
: enter the URL address of the page to use as
your homepage.
•
Proxy Address
: MEdia Net set as the proxy server address
and port. This option only appears when the Protocol is set to HTTP.
• Gateway Address
: Enter the Gateway Address. This option only
appears when the Protocol is set to WAP.
• Secure Connection
: Select On or Off depending on whether or not
you have a secure connection. This option only appears when the
Protocol is set to WAP.
•
Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there is no new data traffic.
•
Advanced Settings
: allows you to configure some of the
IP-specific information: Static IP, Static DNS, Server information,
and Traffic Class. Highlight this option and press the Edit soft key to
access the following options:
–
Static IP
: specify if you want to manually enter an IP address. Remove
the check mark if you want the server to automatically assign the IP
address.
–
Local Phone IP
: allows you to configure the local phone IP address.
–
Static DNS
: specify if you want to manually enter the Domain Name
Server (DNS) address. Remove the check mark if you want the server to
automatically assign the address.