Filter
Top Products
9
Setting Up the WAP Browser
8
Setting Up the WAP Browser
Parameter Description
Profile Name Name that you wish to
assign to the HTTP proxy
server.
Homepage Address of your startup
URL homepage. When the
default homepage displays,
you can delete it using the
C key and enter your own
choice.
Security Data transmission mode.
Choose Secure to protect
your data against
unauthorised access;
otherwise, choose Non-
Secure.
IP Address WAP gateway address
required to connect to the
Internet.
Bearer Bearer to be used for each
type of network address
accessed: GPRS or Data.
The remaining options depend on the Bearer
setting, as indicated below.
When the bearer is set to GPRS
Parameter Description
User Name User ID required to
connect to the GPRS
network.
Password Password required to
connect to the GPRS
network.
APN Access point name used
for the address of the
GPRS network gateway.
Note: The WAP Browser settings may vary,
depending on the service provider. Contact
your service provider for further information.
3. After selecting each of these settings, a dialog
box displays; you can either enter the
information required or choose between given
options. When you are satisfied with your
input, press the OK soft key.
4. When you have finished configuring the WAP
Browser, press the key or the right soft
key.
Configuring the WAP Browser
To configure the WAP Browser:
1. In the WAP Browser menu, highlight Settings
using the and keys, and then press
the Select soft key. You can also press the 4
key directly.
2. Select a proxy server and enter the
parameters required. Contact your service
provider for details
When the bearer is set to Data
Parameter Description
Login Name PPP server login ID.
Password PPP server password.
Dial-up Number PPP server phone number.
Data Call Type Data call type: Analogue
or ISDN.