Sanyo PRO-700 Cell Phone User Manual


 
22 Section 2A: Phone Basics
Turning Your Phone On and Off
Turning Your Phone On
Press .
Once your phone is on, it may display “Looking for service...,”
When your phone finds a signal, it automatically enters
standby mode – the phone’s idle state. At this point, you are
ready to begin making and receiving calls.
If your phone is unable to find a signal after five seconds of
searching, a Power Save feature is automatically activated.
When a signal is found, your phone automatically returns to
standby mode.
In Power Save mode, your phone searches for a signal
periodically without your intervention. You can also initiate a
search for Sprint service by pressing any key (when your
phone is turned on).
Turning Your Phone Off
Press and hold for two seconds until you see the
powering down animation on the display screen.
Your screen remains blank while your phone is off (unless the
battery is charging).
Tip
The Power Save feature conserves your battery power when
you are in an area where there is no signal.