Filter
Top Products
This is the Internet version of the user's guide. © Print only for private use.
27
Calling
To reject a call using voice commands
When the phone rings, say “Busy”.
The call is rejected. The caller is diverted to
voicemail, if activated, or hears a busy tone.
Editing your voice commands
You can keep all your voice commands up to date
by re-recording them or deleting the ones you do
not use. You can also edit a voice command for a
phone number in the phonebook. Select the contact
you want to edit a voice command for
} More
} Edit contact
. Scroll to the relevant tab and edit
your voice command.
To re-record a voice command
1
} Settings
} the General
tab } Voice control
} Voice dialling
} Edit names
.
2 Select a voice command
} More
} Replace voice
.
3
Lift the phone to your ear, wait for the tone and
say the command.
Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should
be around one second long and more than one
syllable.
• You spoke too late or too soon – speak immediately
after the tone.
• You did not record the voice command when the
handsfree was attached – for voice control with
a handsfree kit, record when the handsfree is
attached.
• You used another intonation – use the same
intonation as in the recorded voice command.
Diverting calls
If you cannot answer incoming calls, you can divert
them to another number, for example, your answering
service.
You can choose between the following divert options:
• All line 1 calls
– divert all line 1 calls.
• All line 2 calls
– divert all line 2 calls.
• When busy
– divert calls if you are already
on the phone.
• Not reachable
– divert calls if your phone
is turned off or if you are unreachable.
•
No reply – divert calls that you do not answer
within a specified time limit (operator-dependent).
When the Restrict calls function is activated, some
Divert calls options are not available.