Filter
Top Products
English - 13
x Increase the separation between the
equipment and receiver.
x Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
x Consult the dealer or an experienced radio/
TV technician for help.
RF Exposure Informaon
This product complies with FCC radiation
exposure limits under the following
conditions:
x The base must be placed to allow a
minimum of 20 cm (8 inches) between the
antenna and all persons during normal
operation.
x The base must not be collocated or operated
in conjunction with any other antenna or
transmitter.
x The handset is designed for body-worn
operation and meets FCC RF exposure
guidelines when used with any belt clip,
carrying case, or other accessory supplied
with this product. (All necessary accessories
are included in the package; any additional
or optional accessories are not required
for compliance with the guidelines.) Third
party accessories (unless approved by the
manufacturer) should be avoided as these
might not comply with FCC RF exposure
guidelines.
Industry Canada (I.C.) Noce
Terminal equipment
NOTICE: This equipment meets the
applicable Industry Canada Terminal
Equipment Technical Specifications. This
is confirmed by the registration number.
The abbreviation IC before the registration
number signifies that registration was
performed based on a Declaration of
Conformity indicating that Industry Canada
technical specifications were met. It does
not imply that Industry Canada approved
the equipment.
NOTICE: The Ringer Equivalence Number
(REN) for this terminal equipment is
marked on the equipment itself. The REN
assigned to each terminal equipment
provides an indication of the maximum
number of terminals allowed to be
connected to a telephone interface. The
termination on an interface may consist of
any combination of devices subject only to
the requirement that the sum of the Ringer
Equivalence Numbers of all the devices
does not exceed 5.
Radio equipment
The term IC before the radio certification
number only signifies that Industry Canada
technical specifications were met. Operation
is subject to the following two conditions:
(1) this device may not cause interference,
and (2) this device must accept any
interference, including interference that may
cause undesired operation of the device.
"Privacy of communications may not be
ensured when using this telephone."
Warranty (1 Year, Limited)
Evidence of original purchase is required
for warranty service.
WARRANTOR: UNIDEN AMERICA
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden
warrants, for one year, to the original retail
owner, this Uniden Product to be free from
defects in materials and craftsmanship with
only the limitations or exclusions set out
below.
WARRANTY DURATION: This warranty
to the original user shall terminate and
be of no further effect 12 months after the
date of original retail sale. The warranty
is invalid if the Product is (A) damaged or
not maintained as reasonable or necessary,
(B) modified, altered, or used as part of
any conversion kits, subassemblies, or
any configurations not sold by Uniden,
(C) improperly installed, (D) serviced
or repaired by someone other than an
authorized Uniden service center for a
defect or malfunction covered by this
warranty, (E) used in any conjunction
with equipment or parts or as part of any
system not manufactured by Uniden, or (F)
installed or programmed by anyone other
than as detailed by the owner's manual for
this product.
STATEMENT OF REMEDY: In the event
that the product does not conform to this