A SERVICE OF

logo

Open as PDF
next previous
SET GROUP NAME
2-117
SET GROUP NAME
Use the SET GROUP NAME command to assign a name (up to 16 alphanumeric
characters) to a port group. After you assign a group name, you must identify a
group using this name, not by the group number. For example, if you rename
Group1 to Eng1, you must refer to the group as Eng1 in future management
commands.
Format
Example
The following command renames group1 to Eng1:
CB5000> set group group1 name Eng1
Group1 named to Eng1.
Related Commands
SET GROUP MODE
SET GROUP PORT
SHOW GROUP
group Specifies a group.
For example, the command SET GROUP GROUP6 NAME FINANCE renames
group6 as Finance.
name New name for the group, up to 16 characters in length.
set group
namegroup
name