3Com Switch 8800 Configuration Guide Chapter 46 System Maintenance and Debugging
46-14
Set the
information
output direction
to SNMP
— —
Set information
source
—
You can define which
modules and information to be
sent out and the time-stamp
format of information, and so
on. You must turn on the
switch of the corresponding
module before defining output
debugging information.
Configure
SNMP features
—
Refer to
Chapter 47 SNMP
Configuration
Network
management
workstation
The same as the
SNMP
configuration of
the switch
— —
46.5.3 Sending the Configuration Information to the Loghost
To send configuration information to the loghost, follow the steps below:
1) Enabling info-center
Perform the following configuration in system view.
Table 46-20 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to the loghost
Perform the following configuration in system view.
