Configure Dial-Up Networking 3-23
A dialog box indicates successful setup.
9 Click Finish.
This completes the setup procedure for Windows NT 4.0.
Refer to “Configure Dial-Up Networking” below to setup a
remote access configuration, or continue on to Chapter 5,
“Advanced Configuration,” to review the default settings and
ensure that they reflect your preferences. If you prefer not to
change the default settings, then go on to Chapter 7, “Placing
and Receiving Calls”.
Configure Dial-Up Networking
This section describes the Dial-Up Networking setup
procedure for both Windows 95 and Windows NT 4.0
Dial-Up Networking setup requires specific Internet Service
Provider (ISP) information; your particular setup parameters
may vary widely. You may need to check with your ISP for
assistance.
Dial Up Networking for Windows 95
If you would like to connect to the Internet, you can choose
to have the Internet Setup Wizard to guide you through the
procedure or you may choose to configure Dial-Up
Networking manually for other remote connections.
To configure Dial-Up Networking manually:
1 From the Start menu, select Programs, Accessories, and
Dial-Up Networking.
The Dial-Up Networking window opens.
2 Double click the Make New Connection icon.
3 Enter a name for this connection (such as your ISP).
4 Select 3ComImpact IQ for baud rates up to 115.2 Kbps.
