28 Basic setups
Measurement setup (for community noise)
NOTE: For quick and easy access, there are three optional screens to change
the timed response and the weighting. These are in the following SoundPro
screens: Measures Set screen, View Current Study screen, and View Session
study screen.
Measurement setup (for community noise)
The measure screen is used to select community noise settings for meter 1
only. Table 3-2 below explains the settings and options.
Setting up community noise measurements (refer to figure 3-5 below)
1. Ensure you are at the start screen.
• If turned on, repeatedly press On/Off/Esc until you return to the
start screen (see Figure 3-3).
2. Press Up/Down to highlight Setup and then press Enter .
3. Select Measures from the Setup screen by pressing Up/Down to
highlight and then press Enter .
4. In the Measures screen, press Up/Down to select one of the
measurements. To select second column, first press Up/Down arrows then
press Right arrow.
Figure 3-5: Measures screen for community noise settings
5. To make changes to the data fields, do one of the following:
• L1-L4 - Press Enter to move to the data field. In the data field,
repeatedly press Enter to change your selection.
• Press arrows to change percentage.
• LDN - Press Enter to move to data field and continue to press
Enter to toggle between On/Off setting.
• Edit column 1 or column 2
fields by pressing enter
repeatedly to toggle through
• L1-L4
• LDN, CNEL
• Lc-a, TAKTMX
