Acu-Rite 150 Manual

A SERVICE OF

next previous

• Insert the encoder into the spar.

• Centertheencoderfromendtoendwiththespar.

• LockinplacebytighteningtheM4setscrews.

• Attachthebrackettothemachine.

• Alignthereadingheadmountingholeswiththebracketholes.

• Attachheadtobracket/Setlevelingscrews/Securefasteners.

• Tolocatethereadingheadbracket,attachittothereadinghead.

• Centertheaxisandmarkthebracketmountingholes.

• Removethebracket,drill/tapholesfor1/4-20(M6).

M4x8mmsetscrews

8-32x5/8”SHCS

(M4x16mm)

Do not tighten prior to adjusting

leveling set screws.

Reading head bracket

8-32x5/8”SHCS

(trim if necessary)

SENC 150 Spar Installation Procedure

• Slidethebracketsawayfromthereadinghead.

• Removethealignmentbracketsandsaveforfutureuse.

• Proceedtopage13,“CheckingYourInstallation”.

Alignment bracket

removal

Slidebracketsawayfromreadingheadandcable.

Twist45°

13

ACU-RITE

®

516291-21_Ve00_SENC_150.indd 15 10/22/2009 10:00:45 AM