Chapter 4: Configuring the WAN April 14, 2006
4-12 MM70xG2-UM-03
Step Action
2
(cont.)
The following (Figure 4-7) shows the fields you can edit for a PPP session or you can delete the session.
The Protocol field at the top of the dialog is read-only. It indicates the protocol that you previously
selected for this session.
Figure 4-7. WAN Sessions (PPP)
3 Change session parameters as required. Go to the following pages for parameter definitions based on
the protocol used for that session:
• For an RFC1483-Bridge session, go to page 4-3.
• For an RFC1483-Routed session, go to page 4-5.
• For a PPPoA Routed session, go to page 4-7.
• For a PPPoE Routed session, go to page 4-7.
4 Do one of the following:
• Click Apply, then save changes as described in “Saving Changes” on page 5-12.
• Click Delete to entirely remove the session, then save changes as described in “Saving Changes” on
page 5-12.
