User information
32
Operating problems
Many checks have been carried out during the manufacture of your
washing machine. However, if you face a problem with its operation,
please have a look at the following table before calling the After Sales
Service. Moreover, it is possible that one of the following messages
appears on the display :
Problem with water supply : No incoming water. Check tape
& hose»
Problem with water draining : .....No drain. Check drain hose / filter»
Cover open : ................................................Door not closed. Please check»
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists,
contact the After Sales Service.
Symptom Cause
The washing machine will
not start or will not fill :
• the washing machine is not correctly
connected, the electrical installation is
not working,
• the cover of your washing machine
and the drum flaps are not correctly
closed (Door not closed. Please check)
• you did not control the program start
correctly,
• there is a power failure,
• the water supply is closed off (No
incoming water. Check tape
& hose)
• the water tap is closed (No incoming
water. Check tape
& hose)
• the water inlet is blocked (No inco-
ming water. Check tape & hose)
The washing machine fills
up but empties again
immediately :
• the drain siphon is attached too low
(see installation section).
