12 Agilent 6000 Series Oscilloscopes Programmer’s Quick Start Guide
1 Setting Up
You must manually add instruments on LAN interfaces:
a Right-click on the LAN interface, choose Add Instrument from the
popup menu, and click OK in the resulting dialog (because the desired
interface is already selected).
b In the next LAN Instrument dialog, select either Hostname or IP
address, and enter the oscilloscope’s hostname or IP address.
c Click Test Connection.
d If the instrument is successfully opened, click OK to close the dialog. If
the instrument is not opened successfully, go back and verify the LAN
connections and the oscilloscope setup.
3 Test some commands on the instrument:
a Right-click on the instrument and choose Send Commands To This
Instrument from the popup menu.
