A SERVICE OF

logo

84
Figure A-1. Mating Connector Assembly
Operation
The following paragraphs provide the operating instructions necessary to interface a 002-equipped power supply into an
automated system. A brief description of some circuits is also provided. The unit is shipped for front-panel operation with
mode switch settings as follows:
B1 B2 B3 B4 B5 B6
011011
Before beginning, switch the power supply's rear panel MODE switches B1 through B6 to their correct positions for the
programming source being used, (See Table A-2).
Next switch A1 and A2 also on the rear panel, to the correct program source function, See Figure A-2. All connections are
made at the 37-pin rear panel connector J3, and can be wired directly into the mating connector supplied for this purpose.