MA24106A UG 2-1
Chapter 2 — Installation
2-1 Introduction
This chapter provides information and instructions on operating the MA24106A power sensor. It contains the
following:
• Hardware and Software Requirements for the Anritsu Power Meter Application
• Driver Installation procedure for properly installing the driver for the sensor
2-2 Hardware and Software Requirements
Please make sure that the following minimum requirements are met for installing and using the software:
• Intel® Pentium® III or equivalent processor
• Microsoft® Windows Vista® (32-bit only), Windows XP or Windows 2000
• 512 MB of RAM
• 100 MB of available hard-disk space
• 1024 × 768 display resolution
• PC or laptop with a USB port and CD-ROM drive
2-3 Driver Installation
The driver must be installed before the MA24106A power sensor can be used. Follow the steps below as a guide
for proper installation:
1. Insert the installation CD in the drive of your computer. If the installation menu does not start
automatically, open the file named Startup.htm located on the CD.
2. Click Install Power Meter Application and select Run to start the installation.
Figure 2-1. Anritsu Power Meter Installation Menu
Note: If required, please install the Microsoft® .Net Framework, version 2.0.
