APEX MICROTECHNOLOGY CORPORATION • 5980 NORTH SHANNON ROAD • TUCSON, ARIZONA 85741 • USA • APPLICATIONS HOTLINE: 1 (800) 546-2739
ABSOLUTE MAXIMUM RATINGS
SPECIFICATIONS
PA40
ABSOLUTE MAXIMUM RATINGS
SUPPLY VOLTAGE, +V
S
to –V
S
250V
OUTPUT CURRENT, continuous within SOA 60 mA
OUTPUT CURRENT, peak 120 mA
POWER DISSIPATION, continuous @ T
C
= 25°C 14W
INPUT VOLTAGE, differential ±16 V
INPUT VOLTAGE, common mode ±V
S
TEMPERATURE, pin solder – 10 sec 220°C
TEMPERATURE, junction
2
150°C
TEMPERATURE, storage –65 to +150°C
TEMPERATURE RANGE, powered (case) –40 to +125°C
CAUTION
The PA40 is constructed from MOSFET transistors. ESD handling procedures must be observed.
PARAMETER TEST CONDITIONS
1
MIN TYP MAX UNITS
INPUT
OFFSET VOLTAGE, initial 15 30 mV
OFFSET VOLTAGE, vs. temperature
4
Full temperature range 70 130 µV/°C
OFFSET VOLTAGE, vs supply 20 32 µV/V
OFFSET VOLTAGE, vs time 75 µV kh
BIAS CURRENT, initial 50 2
00
pA
BIAS CURRENT, vs supply 2 20 pA/V
OFFSET CURRENT, initial 50 200 pA
INPUT IMPEDANCE, DC 101
1
INPUT CAPACITANCE 5 pF
COMMON MODE, voltage range ±VS–12 V
COMMON MODE REJECTION, DC VCM = ±90V DC 84 94 dB
NOISE, broad band 10kHz BW, RS = 1K 50
µV RMS
NOISE, low frequency 1-10 Hz 110 µV p-p
GAIN
OPEN LOOP at 15Hz RL =
5K 94 106 dB
BANDWIDTH, open loop 1.6 MHz
POWER BANDWIDTH CC = 10pf, 280V p-p 26 kHz
PHASE MARGIN Full temperature range 60 °
OUTPUT
VOLTAGE SWING IO = 40mA ±VS–12
±VS–10
V
CURRENT, peak
5
120 mA
CURRENT, continuous 60 mA
SETTLING TIME to .1% CC = 10pF, 10V step, AV =
–
10 12 µs
SLEW RATE CC = OPEN 40 V/µs
CAPACITIVE LOAD AV = +1 10 nF
RESISTANCE6, n
o
load RCL =
0 150
RESISTANCE6, 20
m
A load RCL = 0
25
POWER SUPPLY
VOLTAGE
3
See Note 3 ±50 ±125 V
CURRENT, quiescent 1.6 2.0 mA
THERMAL
RESIST
ANCE, AC junction to case
6
F > 6
0Hz 5.9 6.85 °C/W
RESIST
ANCE, DC junction to case
6
F < 6
0Hz 7.7 8.9 °C/W
RESISTANCE, junction to air Full temperature range °C/W
TEMPERATURE RANGE, case Meets full range specifi cations –25 25 +85 °C
SPECIFICATIONS
NOTES: 1. Unless otherwise noted T
C
= 25°C, C
C
= 18pF, R
C
= 2.2K. DC input specifi cations are ± value given. Power supply voltage
is typical rating.
2. Long term operation at the maximum junction temperature will result in reduced product life. Derate internal power dissipation
to achieve high MTTF.
3. Derate maximum supply voltage .5 V/°C below case temperature of 25°C. No derating is needed above TC
= 25°C.
4. Sample tested by wafer to 95%.
5. Guaranteed but not tested.
PA40
