A SERVICE OF

logo

Installation
Page 2-12
Powering on the Hub
The NetStacker II hub may be turned on with (or without) LAN segment
cables connected.
To power on the hub:
1 Connect one end of the power cord (supplied) into the
AC power connector on the back panel of the hub.
β—† Note: NetStacker II hubs are equipped with an internal
power supply. Power sensing is automatic for all interna-
tional utility power.
2 Connect the power cord to a local power source outlet.
3 Click the power switch on the rear panel to the β€œon” posi-
tion.
SHBBook Page 12 Wednesday, March 3, 1999 8:03 PM