2525
2525
25
FLOPPY1
Pin1
the red-striped side to Pin1
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100 cable
FDD connector
(33-pin FLOPPY1)
(see p.11 No. 26)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.11 No. 10)
Note: Please refer to the instruction of your IDE device vendor for the details.
SATAII_BLACK
(PORT1)
SATAII_ORANGE
(PORT3)
SATAII_BLUE
(PORT0)
SATAII_RED
(PORT2)
SATAII_RED (PORT2) and SATAII_ORANGE (PORT3) connectors can be
used for internal storage devices or be connected to eSATAII_BOTTOM
and eSATAII_TOP connectors with corresponding color to support eSATAII
devices. Please read “eSATAII Interface Introduction” on page 31 for
details about eSATAII and eSATAII installation procedures.
eSATA II Connectors These two eSATA II
(eSATAII_TOP: see p.11, No. 37) connectors support SATA
(eSATAII_BOTTOM: see p.11, No. 38) data cables for external
SATAII function. The current
eSATA II interface allows up to
3.0 Gb/s data transfer rate.
eSATAII_TOP
eSATAII_BOTTOM
IDE1
PIN1
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional) SATAII hard disk or the SATAII
connector on the motherboard.
You can also use the SATA data
cable to connect SATAII connec-
tors and eSATAII connectors
with corresponding color.
Serial ATA II Connectors These four Serial ATA II
(SATAII_BLUE (PORT0): (SATAII) connectors support
see p.11, No. 16) SATA data cables for internal
(SATAII_BLACK (PORT1): storage devices. The current
see p.11, No. 15) SATA II interface allows up to
(SATAII_RED (PORT2): 3.0 Gb/s data transfer rate.
see p.11, No. 13)
(SATAII_ORANGE (PORT3):
see p.11, No. 14)
